GChamp

Hi, I am currently using Cura 5.2.1 with 0.4mm nozzle, 0.2 layer height & 0.4 line width. Is it possible to remove or reduce the gaps between the lines? Normally this is not an issue but recently it has been on a few of my prints making them weak at line joints & I would like to have a better surface finish too. I have attached a screen shot from Mainsail G-Code viewer. I have pointed out some of the gaps I am talking about. The part in this picture is small, only 15x20mm, to exaggerate the point. I know a smaller linewidth would help but I don't really want to have to do that as it makes it a much longer print. Any suggestions welcome & thanks in advance.