Ditto

Hi guys, its me again... I would like to ask, where can I buy spare nozzles for the Crazy3DPrint CZ-300? I tried browsing Amazon but so far there are only nozzles for Ender brand printers. I hope to hear from you guys soon, thanks!

Hello! Thank you so much for the advice! I am very surprised at your answer, I didnt know that the CZ-300 can use Cura 5.0+.... I'll try that out thanks!

Hi guys, I am new to this forum and would like to seek your advice on a matter... Recently Ive owned and set up a CZ-300 printer from Crazy3DPrint. Once I have finished assembling it, I printed the bolt and nut file that came with their memory card, and it came out pretty fine [as can be seen in the image included, its a red colored bolt]. After that I installed Cura 4.0 (which was the version I was recommended to download according to Googling), loaded up the CZ-300 printer profile so Cura can "recognize" it. and tried slicing and printing my own item, unfortunately it turned out wrong after 17 hours, as you can see in the images below, it seems that the print was drifting in the Z direction! You can see the "stepping" and "overhangs" I've circled in red. I've checked for loose pulleys or loose fasteners on the bed, but it seemed fine. the Y and X axis has no issue either. Since the bolt print that came with the card turned out fine, I am strongly suspecting the issue to be software related. Did I install the wrong version of Cura for this operation? Or is the problem with the CZ-300 profile code? Please advice! Thank you so much!