0v3rrat3

Hello everyone, I recently gained access to a Ultimaker S5 here at my work and have been playing around with it a bit. I've been able to print a few small there here and there with no problem, but any time I've tried to print something a little larger, it fails on the first layer. I've switched materials and it prints fine, though. I think this is an adhesion problem, but I'm not 100% sure. I've played around with some of the settings, but nothing I've done has worked yet. Does anyone have any suggestions, tips, or tricks? I'm at a loss here. Attached picture is my most recent failed print and is representative of how every "large" print I've tried to make with this material ends up. Filament being used is Polymaker's Polyterra 2.85mm PLA.