Hi,
i build a voron with toolchanger running klipper.
I use cura since 2014 but i cant solve that problem.
i try to explain it.
before toolchange, klipper stores the toolheadposition(blue line)
then retract, z hop, toolchange etc.
after toolchange the toolhead goes to the old position (green line) and do a "unretract"
then i have a little drop of filament on the nozzle
then the toolhead goes to new position (orange line)
with the drop on the nozzle i have the wrong colour at the move from "green to orange" and sometimes you can see it in the print.
i seach a solution how i can delete the G0 (green line) command
a workaround is to set a 5mm z hop, but is does the job not good enough.
Does anyone know how i can do this?
Why is there that unnecessary G0 command?
Thx for help
Martin