[Disabling second extruder should take into account nozzle offset]

@Dustin As I said in the original post it's not an IDEX printer, both extruders are mounted to the same head. I was looking at the add your custom machine to Cura page earlier today.  What would be a good example for me to use as I begin trying to set mine up?

[Disabling second extruder should take into account nozzle offset]

1 hour ago, GregValiant said:

It might if this was MakerGear Cura.  Since it is Ultimaker Cura it doesn't work that way.

It's also an application designed to work for other printers as well so that's kind of a narrow view. Especially since the software already changes various settings by enabling/disabling the individual extruders.

 

The suggestion to setup a second printer might be the way I have to go though so thanks for the suggestion. My printhead actually has the ability to move completly off the right side of the bed to facilitate nozzle purge operations.

[Disabling second extruder should take into account nozzle offset]

I have a Makergear M2 with dual extruders mounted together in the same printhead. As you can see the offset for extruder 2 is -31.1mm and Cura accounts for that correctly as I can't print on the far left of the bed with extruder 2. 

Here's the rub, extruder 1 CAN print anywhere on the bed. Shouldn't disabling extruder 2 by unchecking the box shown below "disable" extruder 2 allowing me to utilize the entire bed?