Luky

Hi, i did the set back and changed the nozzle to a new 0.25. also changed the layer hight so 0.2mm and now it's printing just fine. I found that i must have changed the nozzle to a bigger one at some point. can't remamber when and why, but that was a stupid mistake and propably the problem. 🙄 like i sad i havn't been printing for quite a while. thanks a lot for your help and time! much apreciated!!! All the best.

that sounds very intresting, thank you. i'll try a thicker layer hight now, i got a good fieling about it 😅 we'll see. i let you know. thanks a lot! that was very helpfull.

ok, yeah i need a nice surface, not spacificly on this one, but most of my stuff. but i'll try and play with the layer thiknes. havn't thout abaout it. i also thing 0.06 is "newer" than my printer.. i vagely remamber it to be 0.2mm layer height in the older cura versions, could that be?

i'll try that next.

no, didn't do anything. also its stil showing the old numbers.

maybe 5

no, not that i remamber

Just tryed it, but it seams that it doen't work. it tkes 2 sec. to finish and nothing changes at the desplay.

Not quite shure if i got it right, but i couldn't finde anything else. within cura i also couldn't find any information which firmware in on my printer. if thats the right one, it looks like the update didn't work at all. i'm a bit confused, because there is no + or plus what so ever. so i might be on the wrong track here?

Here are some more pics and i check for the Firmware now.

Sorry for that. that shuld be it right? UM2E_Körper.3mf

Oh 🙃 do you mean the stl? I'm using Cura 5.3.1 Yes, i did. check, but it wasn't checked. I did update the firmware. the feeder is white. and i got a +. it was a automatic update. i'll load up a photo later. thanks so far! Körper.stl

Hi, thanks a lot! so far nothing i tryed to change (spring tensiin etc.) on the hardware worked. here is the file i used. UM2E_Körper.gcode

Thanks a lot, i'll try and see if something helps. here are som more pics.