krowbar69

I'm wondering if it's a software problem, as in settings... anyone have any ideas? anyone use this machine???

I just bought a used ultimaker3 ext, and i'm having problems with the prints. They are coming out bad and i've tried as much as i could, tightened belts, lubed everything, changed filament.

ok, thank you, i have done pretty much everything you mention.... should i start a new thread with pics??

Ok... thanks for getting back to me, and yes that's the only one i can get to work on it.I just bought this printer and very new at 3-d printing. I'm having problems with the quility of the prints are terrible.... wondering if i should to a factory reset... what do you think??

I'm new and im looking in the printer setting and it's set to griffen, is that a good g-code?

Hello, I'm new to 3d printing and new to ultimakers ... i bought a ultimaker 3 extended used, and the last owner use grease of the rails and it's all gummed up.... manual says it uses special oil, and has a coating on the rails.... i have Zoom Spout oiler and have used that on many stuff. Will other oil hurt the rails and is there a coating on them? looks just like their chrome.... Thanks..