TOGMUHONI

Thank you for your quickly answer In fact, to configure the printer, after trying your solution, I-ve found all this information here : https://formation.wanhaofrance.com/slides/slide/slicer-trancheur-611 Then, I can add the printer which can be see in the liste of the printer in the first run of Cura. And, after, I can use the plugin to connect the printer Thank you !! Good night !!

Hello I've installed the last version of Cura (5.4.0) this day. I have a Wanahoo Duplicator 12/230 Printer wich need the MKSWifiPlugin to be recognize by cura But when I launch cura, it is an obligation to configure the printer.... but my printer is not recognize because Cura need the plugin to recognize it.. But as I can't launch cura, I can't install this plugin...... so I can't use Cura Have you a solution to open Cura without configuring a printer ? Thankx in advance