matejkonecny

With Cura 5.6.0 released and including the profile, what are the recommended steps to get to the "base"? Just remove the files added via the zip file?

Now I am curious about your startup code 🙂

I second that, thanks a lot @Slashee_the_Cow. The profile worked for me for Cura 5.5 on Mac. I've printed 1 print successfully (that ain't much but a good smoke test 😉 ) I've seen recommendation to add M413 S0 for disabling the Power-Loss protection (apparently that caused some artifacts on the prints). I didn't see this gcode in the profile, but maybe this is no longer needed? My single print didn't have that artifact so I am not sure 🤷‍♂️ Also I should add that I print via Octoprint so the files are not stored on an SD card but in the Octoprint server.