CagedLeprechaun

i have not used the printer in a while cause i had an issue that broke the hotend and had to replace it, but didn't have the time to till recently. so i don't think/hope it's not a motherboard issue. but was just trying to print a basic benchy to test it after about a year of not being used. boat.zip

after layer 0 at the actual start it just says this ;LAYER_COUNT:160 ;LAYER:0 M107 ;MESH:3DBenchy.stl G0 F7500 X127.771 Y151.43 Z0.2 is it that i just need to type in M104 S200 and M190 S60 after to fix it?

hi this may have been solved before and i am just blind, but at the start of my prints, the bed and hot end heat up to the right temp, and then the temp sets to 0 and the timer starts while it does nothing. i am using Cura on my Longer LK5 Pro. the firmware was just recently updated and i am printing via USB. here is also the current settings, any help would be greatly appreciated.