Sheppy

Thanks so much for the info, I have tried the pause at height also with no luck, my printer just doesn't seem to like the M600 code. I did reach out to Elegoo and followed their instructions again without success. I'm too scared to tell the wife I need a different printer and to be fair the Elegoo has worked flawlessly aside from this issue. At present I am guesstimating where to pause it manually to do the filament change with varying degrees of success. Perhaps a different slicer or the more terrifying update of the firmware is required?!?!?!

Hi All! I am a complete novice to 3D printing but treated myself to an Elegoo Neptune 4Pro a few weeks ago. From the get go I have able to do some very impressive prints using Elegoo Cura 4.8 despite my novice status but I have finally come unstuck while trying to do a two tone print requiring a filament change. I have been trying the post processing plug in for filament change at a specific height and followed the instructions from Elegoo to the letter (below) and still no luck! I examined the g-code and the M600 command is there, at the right level, but still the printer carries on and ignores it. Where am I going wrong?? Thanks in advance! Thanks in advance!