uzig718

Printer: Artillery Sidewinder X2 Running Klipper Linear rails on the Y axis Everything else is stock, printed with blue PETG The photo below shows two photos of benchy's that I've printed right after I did input shaping via ADXL345 (using Klipper). The benchy on the far left is sliced via Prusa, but the others with the zits are all sliced via Cura... And it's showing the zits on both sides, ONLY on the curves near the hull... From the front the hull actually looks decent, it's only leading up to the hull... Has anyone seen this before? It's only Cura that's causing this. I'm currently printing one oriented 90 degrees, and another slowed down, since this print was a test to see if I can print at 3500mm/s since the input shaper says I can do 5000mm/s but I figured I'd go a bit slower, but they are both printed at 100mm/s... Which I will normally print slower but this is a test of how fast I can get it to go. So I'll do another test as well at a lower speed. But does anyone have any idea as to why Cura could be causing this? Thanks! EDIT: Printing at 90 degrees didn't help, same zits showing up... Only in Cura sliced Benchy... Going to try printing slower, and maybe a different model... Link in case the photo doesn't show: https://imgur.com/a/luGcbaT