[Slicing is super slow with Cura 5.6]

I did look at 5.7 pre-alpha and it's a bit too risky, for what i'm doing, but dropping back to 5.4 seems reasonable for the short term.

 

Thanks for the info.

[Slicing is super slow with Cura 5.6]

I noticed that since I upgraded to 5.6 that my slicing times have gone through the roof.

I have one model that takes over 4 hours to slice on Cura 5.6 on a Ryzen 9 3900x with 64GB of ram and a 1TB NVMe drive.

The same model slices in under 2 minutes on Cura 4.13 on an i5 with 8GB of ram and a 512GB SSD.

I'm hoping that 5.7 addresses this as the differences are staggering.

This is not the only model that I noticed such a large difference in slicing times and it doesn't matter which of my printers I'm slicing for. They are all slow.

Printers:
Tenlog TL-D3 Pro
Ender 3 v2
Ender 3 v3 SE