UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I did look at 5.7 pre-alpha and it's a bit too risky, for what i'm doing, but dropping back to 5.4 seems reasonable for the short term.
Thanks for the info.
I noticed that since I upgraded to 5.6 that my slicing times have gone through the roof.
I have one model that takes over 4 hours to slice on Cura 5.6 on a Ryzen 9 3900x with 64GB of ram and a 1TB NVMe drive.
The same model slices in under 2 minutes on Cura 4.13 on an i5 with 8GB of ram and a 512GB SSD.
I'm hoping that 5.7 addresses this as the differences are staggering.
This is not the only model that I noticed such a large difference in slicing times and it doesn't matter which of my printers I'm slicing for. They are all slow.
Printers:
Tenlog TL-D3 Pro
Ender 3 v2
Ender 3 v3 SE