UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Thank you for the reply!
Not a stupid question, I should have included it. I have a creality cr6-se and didnt touch the firmware and I didnt change anything in cura other than the update. After many tests with the post script settings that changed nothing, I figured out the problem was that I always used the same temps between layer changes, but this time I was changing the temp manually on the printer and left the screen on the "tune" screen at the moment of the pause. Seems if the pause occurs while the printer's screen is not on the "printing" screen, the head will reset and smash into the model. I finally made sure to always go back to the printing/progress screen and it's working fine again.