edousk

Was it Comic Sans? Cause I wouldn't accept anything submitted in that font seriously, either 😁.

Thank you for the reply! Not a stupid question, I should have included it. I have a creality cr6-se and didnt touch the firmware and I didnt change anything in cura other than the update. After many tests with the post script settings that changed nothing, I figured out the problem was that I always used the same temps between layer changes, but this time I was changing the temp manually on the printer and left the screen on the "tune" screen at the moment of the pause. Seems if the pause occurs while the printer's screen is not on the "printing" screen, the head will reset and smash into the model. I finally made sure to always go back to the printing/progress screen and it's working fine again. Thanks again!

Hey all, I use Cura's post processing script 'pause at height' for printing in multiple colors. I've been doing this for a while now with no issue, but yesterday I updated to cura 5.7, and now when I pause at the desired layer, my print head parks like normal, but then when I resume, the head now goes down to the build plate, travels while low and smashes into my model!!! I haven't changed anything, just the update. I always used the M25 gcode for pause with no issue where the head would park, then I could resume, the head would lowere, touch buildplate, raise to the layer height, travel to the model and resume printing. Now, pause, park, lower, travel, smash! I tried uninstalling and reinstalling, but doesn't seem to roll back the post processing. Please help, thanks!