champsteve778

I keep on trying to print it and it keeps failing?? Even at 207

also I tried slicing the file as is and got one of these: See the "model errors"

ok thanks so much I will try and retain as much as possible. do I have to add anything to this project after loading 3mf file in cura? talk soon, Steve

ok I am going to look everything over

Slashee? How about this one: saladin-vase-a-3mf.3mf How do I handle the support here? Steve

I can respect that

so I just load the stl file into cura and then the settings will automatically change to what that stl file says? can you actually change the nozzle size?

Lets go one at a time. 1st one: The bull wall decorative... (attached)... it came with two stl files. It says... Recommended print settings: This model is most compatible with FDM. Materials: PLA (Most reccomended) Nozzle Size: 0.4-0.6mm Layer height: 0.12 - 0.2mm Line width: 0.45mm Infill: 10% - 20% Supports: yes Now where do I start? I am pretty sure I can do: Nozzle Size: 0.4-0.6mm Layer height: 0.12 - 0.2mm Line width: 0.45mm Infill: 10% - 20% But the support scares me. Steve HornsDecimate.stl skullHeadDecimate.stl

np the solution was... needed the temperature a little higher....

sorry about that figured out the problem

Hey guys... I am just still a beginnner... Just simple problem today... my ender 5 just stopped printing... this is the second time it did that. See there is a chip that stopped the printer... Anyone know how to stop this from happening again? Or stuff like this just happens sometimes and I have to deal with it? Steve

yeah it may be dried filament in the nozzle area... I took a pin device and cleared it... fingers crossed

whoa man you really know your stuff! so you are saying I should replace the nozzle with an all metal one? does it have anything to do with the filament?

now look at it

new problem... see picture: (it is leaving openings)... anyone know the problem?