Hey! What a coincidence. I was just going to write a topic about this.
I have bought a heated bed "PCB-type". (
http://www.ebay.com/itm/270860324146
)
I have some questions regarding the install, but the Ultimaker hasn't arrived yet so some questions might solve themselves when it arrives.
There should be a connector on the Ultimaker controller for the bed, and the electronics is mounted, but do I need a separate power supply?
This bed should have 12v and about 10A at 100% PWM.
What type of temp sensor is "supported" by the controller?
tpulti-bt wrote 100kOhm Thermistor, I suppose it should be a NTC type?
