tigertiki

I have the same situation, the fan is powered from the USB. So if i remove the jumper from ARD_PWR would be OK ? Regards tt

Cannot get the RepG34 to work ! The marlin supplied with Cura RC1 works after installing with upgrade from within. Also having a printrun installed which will not run at the same time when cura RC 1 runs by sharing the same com4 port (i assume) I tried to print out of Cura1 . for start did not heated up the head ?! I could print from RepG26 with somewhat success. But would like to update to RepG34 and it is not working !Triyng to use the Ultimaker 5d firmware with com3 and it say that "supports RC" and"initializing serial" "attempting to reset reprap" still "not connected" This is my first day with 3D printing...It is a small miracle that i have 3-4 parts printed. (i got my machine 2 weeks ago so i assume is the new arduino..) Regards tt

Just finished mounting the Ultimaker but could not use it with the actual RepG 34. It seems there is no communication, trying to update the software but with no success. However Repg 26 works fine, Had some adventures with Marlin too, could start it eventually but the calibrating process is awkward.. Well this aint a joyride.. please advise.. regards tt