Jump to content

lan

Dormant
  • Content Count

    3
  • Joined

  • Last visited

    Never

Community Reputation

0 Neutral
  1. Hi, I have been trying to print the squinty head model (http://www.flickr.com/photos/98728747@N03/9263653778/lightbox/). The setting I used were: Layer height : 0.1 Shell thickness : 0.8 Top thickness : 1.2 Fill density : 0 Is there any other setting that I should change? Thanks in advance for your advise guys!
  2. Thanks guy for the suggestions, I will try it this weekend.
  3. Hi guys, I am new to this forum and I have been using Cura with my non-ultimaker 3D printer for the last couple of weeks. I found it is far much better than repetier in terms of ease of use, slicing speed, stability and print quality. There are only two minor problems I faced : 1. How can I extrude/retract filament directly using Cura? Currently I have to use repetier to extract/rectract and then use Cura for printing. 2. The print time showed was not accurate. For example, Cura shows the print time is 8 minutes but in actual it took half an hour to print. Hope you guys can help me with those problem, thanks a lot...
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!