Tightened the screws but still lopsided/skewed prints
I read the post “Lopsided/Skewed Prints” by djproductdesign because I have the same kind of problem.
So again I tightened every screw I could find and checked that the short belts aren't rubbing on the frame, just like Illuminarti and gr5 suggested.
But without any possitive results.
The problem appeared all of a sudden and first look to have been gone but now it's even worse.
The firts models where perfect.
– For the firsttime it's slightly visable at the two Owls but I didn't took a note of that because after that I printed some blocks which where okay.
– Than the Mont Saint-Michel became like a dream-print.
It looks like it came back to it's original point, which I think is a bit different that djproductdesign had.
http://umforum.ultimaker.com/index.php?/gallery/image/890-02-mont-saintmichel-s/
After this I printed again some blocks (10x10x10mm) and again these looked fine.
– So I imported a drawing with some more geometrie but this went terrible wrong.
– From that moment everything is printed skewed; the blocks, the Ultimaker-logo-robot...
If anyone has a solution how this can be resolved, please let me know.
Thanks!
PS
I tried to put pictures in this message ... but I think it didn't work out...
check http://umforum.ultimaker.com/index.php?/gallery/album/152-problems-skewed-prints/ to see them