[Cura under windows 10 hangs after a few seconds]

I recently bought a new laptop with windows 10.

I installed cura 4.8. However when I start cura it stops responding after a few seconds. Nothing I do can makes it react. The only thing I can do Is kill the process via taskmanagement.

 

It worked fine on my old windows 7 machine that unfortunately crashed.

 

What can I do ?

 

[Replace defect display on ultimaker original controler]

I have the ultimaker original since 2013. Lately the display started to show sings of old age.

I could not find the original sc204 display but the sc2004 seems a good alternative.

Replacement is easy as shown in this video (

) made by my daughter.

Make sure you have access to good desoldering equipment as with a simple manual pump it did not work.

Hope this helps,

Johnny & Katleen

Belgium

[Serial number on ultimaker original]

Hi,

Support wants the serial number of my ultimaker original. I have looked all over; Where is it located ?

[Ultimaker original Main cable connector broke]

The connector to the printhead of my ultimaker original snaped. Its beond repair. I tried the ultimaker site but no the main cable is not sold there. Where could I find a main cable or one of the white 3 connections connector.

Thanks,

Johnny

[PLA Transparent]

Hi, I tried some transparent PLA

(https://www.ultimaker.com/products/pla-transparent). The print out is some mike like white. I wonder is that what it should be. In my book transparent is what I can see through. Am I doing something wrong ?

Johnny