markusa380
-
Posts
7 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by markusa380
-
-
I recently upgraded my UMO with a modified version of the UM2 Extruder Upgrade Kit, and found the printhead below the TFM coupler to be leaking slightly:
Is this acceptable? If not, how do I fix it?
-
Recently, the readings of the thermistor on my UMO are limited.
A completely cold printhead will show ~120°C, when heating up this value does not change until the printhead actually reaches ~120°C.
Then the temperature readings seem to be accurate within a margin of error.
This all wouldn't be a problem, if the printer wouldn't abort heating before the printhead reached said thereshold.
Of course the first thought is about a defect component, so I replaced:
- The thermistor
- The thermocouple
- The Ultiboard
- The Arduino
I also checked the cables, of course.
On the new arduino I flashed a customized fork of the Marlin firmware available on GitHub, forked from the Marlin_UM_HeatedBedUpgrade branch.
Here's the link to my repo: https://github.com/MarkusA380/Marlin
What could be the problem?
-
Hello,
I fear that my complete Hotend is starting to slowly give up on me, the wood is starting to bend and the screws got weak.
So I am thinking that I would like to have a drop-in hotend, like this:
But does this UM2 Hotend even work with my UM1?
If not, what can I buy instead? I want to stick to 2.75mm filament.
Greetings,
Markus
-
Also, do I need to plug the power in without an UltiController? If so, the light on the power supply unit goes off if I turn the switch on.
-
No, I dont have an UltiController.
-
Hello guys out there!
I am having a problem with my newly assembled Ultimaker Original:
It just doesn't heat up.
I am running it over USB and as I have read, the fan on the bottom should turn on then. It also doesn't, i can have the switch turned on or off or the power supply cable plugged in or not. Nothing seems to work. Did I make a mistake?
Greetings,
MarkusA380
Slight leaking on UM2+ printhead
in Improve your 3D prints
Posted
I don't have any leaking on the printhead, so I think it's the copper paste, I wasn't aware of it!
Thanks!