Jump to content
Ultimaker Community of 3D Printing Experts

andy3dl

Member
  • Content Count

    4
  • Joined

  • Last visited

Everything posted by andy3dl

  1. When swapping filament, I select change material, it heats up and reverses material with no issues. When feeding new filament, I cut filament to ensure a flat end, then push it into the feeder, wait until the end just shows and click OK on the printer. Filament moves along the bowden tube and into the print head. It's here that the filament seems to stop (if I look at the small indentations on the filament through the bowden tube, relative to the clips it seems to be stationary). No filament at all comes out of the nozzle. I've tried to heat nozzle up to 260 and use the move material opti
  2. Hi, the quality of the prints was fine-no signs of under extrusion. Printed 4 or 5 things without any issues, it was only after changing and loading filament that no plastic at all came out of the nozzle. I had to re-adjust the feeder spring again as well as do an atomic clean. I'll try changing filament back again and see if the problem happens again. Thanks for your reply.
  3. andy3dl

    New print

    Version 1.0

    6 downloads

    New print
  4. Hi all, I've recently got an UM 2+ extended at my workplace and have a couple of issues with it, firstly on the initial print the filament did not extrude from the nozzle. I did an atomic clean just to confirm that there was no clog (which didn't seem to be the issue), I then adjusted the tension on the feeder and was then able to print ok. Great I thought. I then changed filament and same thing happened, repeated above process of cleaning nozzle and adjusting tension on feeder and managed to extrude plastic. Have people has similar issues on the UM2 +? I have been using a UM2 for around 2
×
×
  • Create New...