Jump to content
Ultimaker Community of 3D Printing Experts

donald-lindsay

Member
  • Content Count

    4
  • Joined

  • Last visited

Everything posted by donald-lindsay

  1. Brilliant thanks tinkergnome. It must have been that, a firmware update fixed the problem.
  2. I've been using Ultimaker about five years, Ultimaker 2 since 2014. The printers have given me a fairly easy ride I think though, as despite heavy use I only found the need to replace a part very recently. The failed part was the main board, and having installed the new main board from Ultimaker today, I powered up, and noticed a strange behaviour during bed levelling. Levelled the bed anyway, and attempted a first print with the new board. The video shows what happened : https://www.youtube.com/watch?v=AU1R2G7aKgY The issue shown here is more or less the same as happen
  3. Here's a video of my recently printed bagpipes Just goes to show what these printers can do! For good tone, post-production (basically, polishing all the inside bore surfaces) is important. After that, a quick shine-up on the outside with very fine (wet) sandpaper and 0000 steel wool, and even pipers don't believe me at first when I tell them these are 3D printed They're lightweight, comfortable, and have a good response. I'm going to play them to bring in the bells this Hogmanay (New Years Eve)
×
×
  • Create New...