treth
-
Posts
5 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by treth
-
-
I'm using Cura 15.02.1 installed today and I seem to have this retract on abort issue on my UM2!
Today is the first time I have aborted a print, so can't comment on previous versions. I'm sure all print settings are at their default except for wall thickness and print speeds etc.
-
Excellent, thanks!
I should have dug out the excellent install manual, but didn't realise I would need it again.....
-
This post as been very useful for another Newbie on their 3rd print!
This time using my own design created in DesignSpark Mech (with which I'm also a Newbie!).
My only problem is I was prompted to upgrade Cura and the firmware today and I'm not sure that went correctly as I'm now getting pillowing which I didn't before, but the photos and the setting are most useful thanks.
-
Was prompted to update Cura to 15.02.1 which I did and then to update the firmware which I also did. Then UM2 starts as 'new' so did setup, but when it came to the fine settings with a piece of paper under the nozzle for the front left and right positions the rotating button has no affect so cannot fine set!
There was not a rear left and right fine height setting either (think there was on last version installed).
Should I re-install firmware, if so how? or is it a bug?
15.02 RC2
in UltiMaker Cura
Posted
Hi, as you will be aware I'm new here!
What is the latest release?
Can someone please explain the difference between 15.02 RC2 and 15.02.1
I have seen issues with 15.02.1 such as the filament retract issue on pause/abort, is this being fixed in RC2 which will later become 15.02.2?
Many thanks