Jump to content

renato-elias

Dormant
  • Content Count

    1
  • Joined

  • Last visited

    Never

Community Reputation

0 Neutral
  1. I've already got success in restarting a printing job using method #2, however, I was just wondering why Cura does not log in a file the layers that were successfully completed. It would make our lives much easier when restarting a jog. Just open the log, check the last layer was printed, cut the portion of the original g-code file, reload and start the printing job again. What no log is created by Cura while printing? (or if it's created... where it is?)
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!