[Thoughts about the new Cura]

Hi Guys,

Is there going to be a Printrbot support?

[Raised Edges - Simple Metal]

Nope, I do have only one extruder

 

[Raised Edges - Simple Metal]

Hi there,

Yep i will try with 0.1. Thanks for suggesting this.

I am printing at 195 -197C and my printing speed is 50.

I can try to lower the speed to 30 and temperature to 190C - just to test.

Will come back with resultsrobably tomorrow

[Raised Edges - Simple Metal]

Just a thought maybe it it because of Z-Hop. Mine is 0.075

 

[Raised Edges - Simple Metal]

Ok...

I have just printed some tests.

Settings are the same

1. Two cubes with option print all at once. And they are perfect!!!

2. Just a single cylinder. It has two seams

3. One cube - seams on two corners again

There should be a solution, I can't print all parts two times ))

 

[Raised Edges - Simple Metal]

From the post,It looks like there is no solution :(

Any other ideas.

I will try to print a simple cylinder just to see if it is a Z_scar

 

[Raised Edges - Simple Metal]

Thank for your guys.

Yes, I have tried to print more then one cube, with and without brim.

Both cubes have the same issue and only from one side!

I have tried to rotate them the issue still from the same side.

It looks like it is a point where hot end stops and starts to print next layer.

 

What does Z- seam means and how to fix it?

 

Cheers

 

[Raised Edges - Simple Metal]

Hey Guys,

I have tried to print 5 more cubes and and they all have this problem.

Cant find a solution!

 

[Raised Edges - Simple Metal]

Sorry, image attached

[Raised Edges - Simple Metal]

Hi guys,

I have started to use Cura and all my prints are almost perfect except one problem.

I have found same issue on this forum but couldn't fix it on my Printrbot Simple metal

I basically have raised edges, it looks like over extruded, but I have reduced filament flow and still have the problem.

But what interesting if I print a cube it happens only on two corners . please see image.

Thanks for your advice.