savak001
-
Posts
54 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by savak001
-
-
Thanks for the reply
Yes the thrid fan is working.
We have 8 of the UM2's and they all show the same problem and most have printed over 200 hours.
-
HI All
Almost everytime I start a print on our UM2 the filament does not extrude even after having just printede a model.
I find I have to 'Move Material' remove the Bowden Tube at the nozzle end advance the filament and cut off the end of the filament that comes out looking like this:
Then when I start the print it works ok.
So how can I avoid this process?
Regards
Graeme
-
Hi all
I know this has topic has been discussed concerning grinding of the pla.
My question though is would a solid rubber driver wheel be better suited than the supplied knurled wheel? My thinking is quite simple in that this would avoid grinding and the PLA being delivered by a friction only drive mechanism.
As yet I have not located a suitable wheel to try this out but I would appreciate your expert views.
Another issue I have is the age old one of the first layer being patchy. Your recommendations on this would also be welcome.
Thanks in advance
Graeme
Filamemnt feed at hot-end?
in Coffee corner
Posted
We are using the latest firmware as installed from Cura 15.02.1.
Filament is Colorfabb PLA used at a temperature of no more than 230c.