-
Posts
4 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by AngryPancreus
-
-
In my experience... I was sure the bed was level, and later.. seemed off. I realized just because the bed level wizard went ok in the beginning, didn't necessarily mean the prints will turn out in all layer heights. I start with the wizard, then move onto doing a basic print at the highest resolution(0.04mm). As it begins to do the brim, raft, or skirt.. I adjust the screws further until it puts down perfect sticking lines. This has been my key to success to acheive ulti-quality prints that stick. I take my glass out to wash regularly, move the z axis by hand, etc. and don't need to relevel.
-
Hey Neotko.. i've been trying to figure out the perfect way to add dual extrusion to the UMO+ and the power supply issue is the only thing in my mind... In my research, the UM2 runs a 24V, 25W heater. Nothing from UM documents say the bed runs 25W but thats just what ive read a few places. In my mind, you should have no problem in theory running a lower wattage heater. If I had all the stuff to test, i'd put a bit more resistance on my stock heater and see if I can drop it down to say. 30w. it would just take longer to heat, correct?
- 1
-
Although the designs differ slightly with our heated beds.. I had this issue for a brief bit on my UMO+. Have a good check of the wires and connections to the board. On mine, I gave the wires some slack, and checked the connection of both sets of wires. Fixed my problem.. sounds like it's something simple
Got a spare Ultimaker Mainboard and Power supply, what printer to build with it?
in UltiMaker 3D printers
Posted
How did you successfully install the head? did you follow the instructions from this page? http://reprap.org/wiki/Ultimaker_Diamond
and did you follow the Ultimaker 2 version? or the Original version?
I'm mostly curious to see if you had to drill holes to relocate your end stops.