-
Posts
3 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by MetaCAD2010
-
-
-
I had this problem with a 0.25mm nozzle until i realised that not just changing the nozzle size on cura was essential , but using a higher flow rate to build pressure. this takes some tinkering.
Anyone else found this or just me?
adaptive speeds
in UltiMaker Cura
Posted
is there a setting that says at this height slow down to 50% speed then ramp up to 75% at another height.
I know about adaptive layers but this needs more manual control