UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
is there a setting that says at this height slow down to 50% speed then ramp up to 75% at another height.
I know about adaptive layers but this needs more manual control
use one of these
To clean PVA core use one of these. just lightly push n twist , then push through PLA then repeat and all the soot and crystalised PVA will come through.
I had this problem with a 0.25mm nozzle until i realised that not just changing the nozzle size on cura was essential , but using a higher flow rate to build pressure. this takes some tinkering.
Anyone else found this or just me?