-
Posts
21 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Yohanes
-
-
Hmmmmt.... Because I think the SD Card Often we Remove and Plug. So May be SD Card Can infected Virus.
I hope the ultimaker alright about it.
-
Why? Because I think so simple if I print the project directly from a PC or Laptop.Rather than I Print Via SD Card. Hee heee...
O Ya.. What the ultimaker System may be Infected with the virus? If Yes?
How To Solve the Problem?
-
Hallo Everyone,:)
I Want to ask about what the ultimaker can to Printing Without SD Card? So From PC or Laptop use USB Cable to Ultimaker?
-
Ok Mr. Labern Thank you Very much for your attention and your help for me.
- 1
-
maybe Strenght of XT similar with ABS, yes or no? but it have a some warping and not smell.
The attractive materials
maybe I will to try the material.
Thank you Mr. Labern
-
Yes I think so.
I try with ABS but failed result, and then I try with PLA and so easier.
But I'm a curious with ABS. heee....
-
Thank You For your information Mr. Zoev89
-
Thank you for your information,
XT is a better than PLA I think, so what about XT be compare with ABS?
ABS is familiar with human cos ABS is environment friendly materials.
so what about XT?
-
XT Filaments From Collorfabb is a type of material??
and Ultimaker to Provide the material??
XT Filaments From Collorfabb is harder than PLA?
-
Haa...
I Was to try with My Ultimaker Setting but the result is same.
and now I try printing with PLA material and Binggo is so Good result Haa.....
But I'm Curious about ABS, why is very difficult to the setting??
Anybody to share the experience with ABS to me? haaa....
This is the result when I used PLA material.
Thank you very much for Mr. SandervG and Mr. DidierKlein
-
Ok, I will to try printing with PLA.
Thank You for your Information.
-
What should I do?
There should be to setting in the Printer?
I was try to setting Speed till 80%, The print quality is a high quality. and then temperature at the plate is 95 C.
You have other settings? can you share with me?
-
Haaa... I try and try with another settings but I have a same result. Oh my God haa...
Maybe I want to try with PLA Material.
-
ABS
I follow your suggestion but I have a Same result.
have you another suggestion for me?
-
-
I send you my video.V_20150827_135856[1].mp4
-
Thank You Mr Didier Klein For Your Attention.
My Printer Is Ultimaker 2.
I've done all the procedures from Ultimaker but the result remains the same.
and now I fell so confused haaa....
But your explain to me so after I apply the some glue and then I also apply smoothly on the glass with a slightly wet cloth, and I want to try your suggestion. Mr Didier Klein, I use
Cloth with warm water or cold?
Thank You Very Much
You've taken the time to help me
-
My Name is Fredhi, I'm from Indonesia.
I want to ask about if I want to print my product, I has a Problem.
My produt would not stick to the glass board.
Can anybody to help me?
Sorry if anybody not understand with my message, cos I can't speak english well.
Thank You.
How to remove the Support material after printed at Ultimaker?
in Improve your 3D prints
Posted · Edited by Guest
Please Tell me about, How to remove the support material after printed at Ultimaker?
Or How to setup the 3d Print so that we can easy to remove the support material?
Thank you for your attention.