Rahn
-
Posts
3 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Rahn
-
-
-
Good afternoon all,
I just installed the olsson block to our Ultimaker 2 and attached the 0,25 nozzle.
I printed at first the ultimaker robot with normal settings (normal quality - quick settings out of cura)
The Result is the Robot on the left - i think this is very bad quality.
After this i leveled the bed once again and changed the temperature to 220°C (printing the standard grey PLA from Ultimaker)
Thickness is 0,1mm
Wall thickness is 0,5mm
Retraction is on
Infill 0,6mm
20%
Speed 20mm/s
Nozzle 0,25
First layer 0,18mm
Air Gap 100%
What do you think i can tune to get a better result, i still see some "lines" at the back.
Thanks for your help!
Best regards
Flexible Filaments
in Materials & profiles
Posted
Hi everyone,
did someone of you had any experiences with flexible materials ?
I tried formfutura flexifil but it was not flexible as expected. It was very hard and immobile.
Are there any other filaments which are more flexible?
Best regards!