[Flexible Filaments]

Hi everyone,

did someone of you had any experiences with flexible materials ?

I tried formfutura flexifil but it was not flexible as expected. It was very hard and immobile.

Are there any other filaments which are more flexible?

Best regards!

[Ultimaker 2 - Printing the Ultimaker Robot]

I changed to the 0,6mm nozzle.

Leveled the bed once again and printed another project.

Now i see the following issue, do someone know where this comes from?

Cheers

[Ultimaker 2 - Printing the Ultimaker Robot]

Good afternoon all,

I just installed the olsson block to our Ultimaker 2 and attached the 0,25 nozzle.

I printed at first the ultimaker robot with normal settings (normal quality - quick settings out of cura)

The Result is the Robot on the left - i think this is very bad quality.

After this i leveled the bed once again and changed the temperature to 220°C (printing the standard grey PLA from Ultimaker)

Thickness is 0,1mm

Wall thickness is 0,5mm

Retraction is on

Infill 0,6mm

20%

Speed 20mm/s

Nozzle 0,25

First layer 0,18mm

Air Gap 100%

What do you think i can tune to get a better result, i still see some "lines" at the back.

Thanks for your help!

Best regards