shaihem

Very well, but I need something generic if possible

Hello everyone, Is there anyway that I can tell cura to ignore printing any part of a model that needs support? Let say I have hollow cube, the roof will need support, so by doing what I said, the cube will be printed except the roof. Any ideas? Best

Also the layer height is .3mm

Ultimaker 2 extended + Any print that I print and is hollow from inside, the printer acts as if the retraction is off although it is enabled.

Hi! This is my first participation in this wonderful community. I printed a vase but within the print there are lines all over. While it should be empty from inside. Retraction is enabled. PLA and ABS not working. Slow speed wouldnt make a difference. What do you think?