[Ultimaker 2+ connect]

Hi

Thank you for your help, 👍

[Ultimaker 2+ connect]

Hi,

I have just installed the Ultimaker 2+ connect firmware 1.1 , and when I load the filament , the feeder loading speed is not fast as it should be , it is loading the filament very slowly as if it is loading filament for printing

anyone can help?

[S5 taking hours to power on.]

I have this problem with UM3

[UM3 does not complete the job, and stop at the middle of build]

The previews are correct in both windows 7 & 10

 

[UM3 does not complete the job, and stop at the middle of build]

I think it is windows 7  that is causing the problem , I tried to change the USB first and it was not the USB issue, then I tried the same project on windows 10 and the slicing given time was 2h 50min , while on windows 7 the time was 39min only , noting that I used the same profile setting on Cura 4.2.1 

[UM3 does not complete the job, and stop at the middle of build]

in the preview the slices are complete , and it shows the whole object , and the display says remove object from build plate

At the moment I can't share the file , as I am not in front of the printer

[UM3 does not complete the job, and stop at the middle of build]

it look like the print is finished , and I am printing via USB

[UM3 does not complete the job, and stop at the middle of build]

Thank Smithy

I am using Cura 4.00 ,to print with UM3 refurbished, I tried the default profile normal without making any changes on the settings , and the job starts normally , but the printer stops printing in middle of job, the job ends at the middle of the item and the build is not completed

 

[UM3 does not complete the job, and stop at the middle of build]

I am using Cura 4.00 , and the UM3 stop printing at middle of the build, I am using the cura normal profile sitting with out any changes

 

[UM3 print head movement]

Hi

I just installed a new UM3 EXT and the print head is not moving to the right distance so that it can reach the white plastic piece which used for raising the BB core, I have a video but I can't upload it as it is .mp4 

[UM3 Hotend/ core cover door]

Hi Smithy

Thanks it works, the cover is latching now 👍

[UM3 Hotend/ core cover door]

thanks Smithy for your reply , the door hinges are working good , but the magnet is not latching , so I have to use tab to keep the door closed

[UM3 Hotend/ core cover door]

Hi

I removed the silicon nozzle cover, after I did that , the cover door no longer close and the magnet on longer latching

 I did nothing except that the silicon piece is not fixed , any one knows what to do for the magnet to latch ?