Jump to content
Ultimaker Community of 3D Printing Experts

Zwakie

Dormant
  • Content Count

    81
  • Joined

  • Last visited

3D Print posted by Zwakie

  1. Smartphone Supercharger

    Credit where credit is due: I found this fantastic design on Martin Hansen's website (http://www.mysupercharger.net) and decided my phone needs a supercharger exactly like this beauty
    Completely printed in Innofil3D PLA (white, grey and red). Photo shows test-fit as it came of the bed with a minor bit of sanding on the base and grey rods to allow assembly.
    (apologies for the crappy photo)

    1,295 downloads

       (0 reviews)

    0 comments

    Updated

  2. First print with Innofil3D PRO 1 White

    Came out pretty good for a first try with the Innofil PRO white.
    This test print was also used to test gradual infill steps. I used 40% line infill with step height of 1.2 mm, not being sure if printer could handle laying down the denser layers with too small a step height. It turned out that 1.2 was a bit much, I am confident that .6 will work just as as fine - will test that sometime soon...
    A tiny bit of stringing between the pillars and an occasional 'blob' where it started printing the outer wall, other than that I am quite pleased with this first result (just a little fine-tuning will lead to perfection - I hope ).
    I truly love the shiny surface and the 'translucent' effect on the thinner parts of the print.
    If you have recommendations for improving quality, please let me know!

    1,021 downloads

       (0 reviews)

    0 comments

    Updated

×
×
  • Create New...