Jump to content

Nickcap

Dormant
  • Posts

    5
  • Joined

  • Last visited

Posts posted by Nickcap

  1. is the file .gcode extension.

    have you setup cura with the correct filaments and printcores as your ultimaker.

    is your print too big. (bigger than the print area)

    these are some of the issues i assume that could happen

     

    Yes, the file is .gcode. And it should be able to print. One of the prints i tried printing using USB, i printed using Cura over the network with the exact same settings.

    But thank you :)

  2.  

    I hoped that i would be able to control the printer from Cura using my external IP but it doesn't look like it works.

     

    If you want to do that, you would also have to forward port 80. I would not recommend you do that though, as you open up your UM3 to the world.

     

    Damn. I really want to do this but i can see that it's quite a risk.

  3. Currently i'm monitoring my UM3 from outside my home network by opening port 8080 and using my ip address followed by ":8080/?action=stream" like this:

    [iP Address]:8080/?action=stream

    I hoped that i would be able to control the printer from Cura using my external IP but it doesn't look like it works.

  4. Hello

    I just received my Ultimaker 3 last week and it's printing fine using the network print but when i try using the 'Save to file' in Cura to a USB flash drive and printing from it on the Ultimaker. The printer quickly starts to home but immediately stops and tells me that it has finished printing.

    What is causing this?

    I've tried using different models and both the stock USB drive and 2 of my own. I also tried using third party slicers like S3D and Slic3r.

×
×
  • Create New...