UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
thanks, A few days ago I installed the 3.7 and print perfectly, I dont know what could happen with the 4.0 because I installed it three times and it was not solved
I did a factory reset after updating and then updated by USB but it was not fixed, what I want is to go back to version 3.7 because in another ultimaker 3 that I have has version 3.7 and prints fantastic
I did a factory reset after updating and then updated by USB but it was not fixed, what I want is to go back to version 3.7 because in another ultimaker 3 that I have has version 3.7 and prints fantastic
since updating the printer prints very bad, using PLA and the contour of the piece is wavy, as if the layers were not aligned and I want to know how to return to the previous firmware that if I'm not wrong is the 3.6 ..., help please