hermusrudy
-
Posts
4 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by hermusrudy
-
-
It looks like under extrusion but it could be you don't have enough top layers. It's about 50% underextrusion if that's the problem. How many top layers do you have?
If it's doing ugly walls also - with some holes - then it's an underextrusion issue and I'll give you my complete list of possible causes.
Thanks for your response.
I use 5 top layers for this print. The walls are not perfect but not as bad as clear underextrusion problems that I can find on this forum.
I have already done some things to counter underextrusion. Changing print settings does help, but my prints are still less qualitative than before.
I would love to hear from you, kind regards.
-
-
Hoi,
Kan iemand mij verder helpen? Sinds een tijdje zijn mijn prints niet mooi meer. Ik gebruikte altijd, zonder problemen, de standaard instellingen van Cura (alle versies). Maar tegenwoordig zien m'n prints er zo uit, zie foto's.
Ik heb de aandrijfriemen, hot end en coupler al eens vervangen. Zonder resultaat.
Als iemand mij kan zeggen op welk probleem ik best kan verder zoeken, of een oplossing heeft, dan hoor ik het graag.
Alvast bedankt.
What's the problem?
in Improve your 3D prints
Posted
I use a 0.4mm nozzle. The line width stood at 0.35 mm the bottom / top layer at 0.75 mm.
This print (see photo) shows the line width at 0.4 and the bottom / top layer at 1mm.
There is some improvement but it is still not as it should be.
Thank you for the reply.