***************+++++++++++++_______________++++++++++*************
@All thanks for contributing to the time lapse topic.
the above quote discusses a previous built in time lapse capability.
This would be useful for me as I print and run out of the office.
Curremtly ,after unclogging, the the nozzle is leaking and it's touch and go.
I started a print last night with CPE AND TPU and the temp remelted crystal PLA.
Steam began blowing from the fan and globs of maple syrup randomly smeared early layers.
I had to leave. I'll post the results.
@Unlimited Bacon @MarcoTvM @HarrryPlotter et al:
Wish List
1. Integrate the layer snapshot timing.
2. Add uploading of the completed file so no open ports or Pi's are needed.
Attached is a photo of the plug removed from the nozzle.
After separating the nozzle I put it in the microwave in a mug of soapy water.
With bit of coaxing and wiggling it came free.