[Problems with CURA 6.0 slice]

Thank you so much. It has worked.

[Problems with CURA 6.0 slice]

Hi everybody,

I'm trying to print a piece with TPU but when I try to slice it CURA don't show me how it has worked. In the first picture can be show the piece without any slice, and in the second one the layer view can be seen with shadows. If anyone can help me I would be so proud.

 

[Gap in Breakaway]

My first option was that but it doesn't worked. Putting 0mm as a Support Z distance it still have a gap. As a consecuence the surface is not as flat as I espected.

[Gap in Breakaway]

Hi 

I write here because I'm using Breakaway and I can't remove the gap between the TPU and Breakaway (picture). As a result, The surface is not enough good. 

I hope you can help me

Thanks 

[Support material for TPU]

Hi everybody

I would like to know if there is any support material for TPU. I have tried with PVA but the results were unsuccesful.

Thank you for your help.

[Overextrusion with TPU95]

Thanks for the solutions, I will try IT and I will show you how It has worked.

[Overextrusion with TPU95]

Hi everybody

I´m extruding with red TPU95 and PVA testing the compatibility. The problem is as soon TPU95 stop extruding for building, and the PVA start printing, the TPU95 keeps melting a short flow of material instead of stopping. As a result, There exist an undesireable overlap between of both materials.

I've tryed changing the "retraction extra prime amount" to 0 but It doesn't work. 

If anyone can help me I would be so pleased.

Thank for your attention