Jim8163
-
Posts
8 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Jim8163
-
-
-
I did try while Cura is running and it still did not work. Is there anything else that might be causing it not to work?
-
I've never had a problem designing parts on Fusion 360, clicking on "3d Print", selecting the part, clicking "Cura" as the print utility and hitting "OK". Cura then pops up and I slice it and save it on my Ultimaker SD for printing. Now Cura won't even pop up after selecting the part and clicking "OK" like it always did before. I've uninstalled Cura and reinstalled it twice with no luck. I even upgraded to 4.8 and have the latest Fusion 360 version. Any suggestions? Jim
-
This did work not.
-
On 10/21/2020 at 2:10 AM, Smithy said:
Does it work when Cura is already open? I am on the Mac and for it works only when Cura is open because Fusion is not allowed to start a new application.
Sorry about the delay in responding to your answer but no-it still does not work when Cura is open
-
I've never had a problem designing parts on Fusion 360, clicking on "3d Print", selecting the part, clicking "Cura" as the print utility and hitting "OK". Cura then pops up and I slice it and save it on my Ultimaker SD for printing. Now Cura won't even pop up after selecting the part and clicking "OK" like it always did before. I've uninstalled Cura and reinstalled it twice with no luck. I even upgraded to 4.7.1. Any suggestions? Jim
-
During assembly of the Original+, I broke the black plastic bolt clip ( pg 79 fig 221 of assembly manual) that holds on the knurled drive bolt of the feeder assembly. Is it possible to buy or get a replacement? It was part of the injection mold pack.
Cura not working on Fusion 360
in UltiMaker Cura
Posted
It did for you-not for me. I was enjoying this hobby until the new Cura upgrade . I haven't been able to print since.