jogul

Figured it out. New to a lot of this stuff. Installed Marlin on the 2560, connected to Cura 5 and upgraded firmware. I think I am good to go for now. Try it out tomorrow after reassembly.

Stumped. I finally sourced a replacement MB for my Original and bought a new Arduino 2560 to go with it (old 2560 was shot). I plugged in my power supply and the green light comes on on the MB, however the USB will not connect. What do I do? Would really appreciate some help on this.

Are there any on the market?

ok

I have blown one of the stepper drivers on my Original and wondered what I can buy as a replacement.