Jump to content

Calmc545

Member
  • Content Count

    3
  • Joined

  • Last visited

Everything posted by Calmc545

  1. Prusa Mendel I3, nozzle size 0.4 mm, material diameter size 1.75mm. Everything seems to match with the Monoprice specs. Could a clog be the issue?
  2. It's not a Ultimaker, it's a Monoprice Maker Select v2, but it uses Cura. So this is definitely a physical flaw, not an effect of the settings? What is the function of the TFN/TFT?
  3. I've been playing with the settings, mostly slowly down the print speed in Cura. I'm not sure why the quality of the print is so low. This printer use to produce high quality prints at much faster speeds. Is this just a setting error? Is it possible that I need a new nozzle or something else? Any advice will help. Current Settings: Plastic type: PLA Extruder Temp: 210 C Fill Density: 15 % Infill Speed: 65mm/s Outer Shell Speed: 30 mm/s Inner Shell Speed: 60 mm/s Layer Height: 0.1 mm
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!