-
Posts
5 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Rotor_Blade_Guy
-
-
thank you all for your help. I restarted printer. Interestingly after that I was unable to immediately go to the settings/maintenance and access firmware update. I was busy with some other stuff and a bit later when I came back to it printer suggested I update firmware. I opted not to, navigated to the maintenance screen and chose to update firmware that way. It worked.....
Not sure what to make of it other than problem solved, moving onto bigger/better things.
thanks again.
-
-
-
Random paths in top layer
in Improve your 3D prints
Posted
Hello,
I am getting path lines in the finish layer which I would like to avoid. Majority of the layer is built using symmetrical pattern but there are movements that end up cutting across and leaving lines that now I have to figure out how to 'blend out'. Is there a setting in the Cura that would enforce behavior that would eliminate this from happening?
I am using Ultimaker S5, Cura 4.4.1 and Ultimaker Tough PLA filament
Thank you for your help.