UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I hope that all is well. Recently I have been facing infill problems with my 3D prints on the Ultimaker 2+. I'm not sure why the printer is unable to finish the infill patterns. If you look at the pictures attached to this, you'll see that some of the grind lines are not complete. From the right to left, I have changed the speeds for each print to improve the quality but the infill problem keeps showing up, I'm unable to figure out why. Any help/suggestions will be appreciated.
Trouble with infill pattern
in Improve your 3D prints
Posted · Edited by Leoboghozian
Hello everyone,
I hope that all is well. Recently I have been facing infill problems with my 3D prints on the Ultimaker 2+. I'm not sure why the printer is unable to finish the infill patterns. If you look at the pictures attached to this, you'll see that some of the grind lines are not complete. From the right to left, I have changed the speeds for each print to improve the quality but the infill problem keeps showing up, I'm unable to figure out why. Any help/suggestions will be appreciated.
My last setting:
Software: Ultimaker Cura 3.6
Material: PLA 230 C
(Quality)
Nozzle: 0.4 mm
Layer Height: .18 mm
Initial Layer Height: .18 mm
Line Width: .35 mm
(Shell)
Wall Thickness: 1.2 mm
Wall Line Count: 3 mm
Top/Bottom Thickness: .8 mm
Top Thickness: .8 mm
(Infill)
Infill Density: 20%
Infill Line Distance: 5.25 mm
Infill Pattern: Grid/Triangle
(Material)
Initial Layer Flow: 100%
Retraction Min. Travel: 0.8 mm
(Speed)
Print Speed: 40 mm/s
Infill Speed: 30 mm/s
Wall Speed: 30 mm/s
Outer Wall Speed: 30 mm/s
Inner Wall Speed: 30 mm/s
Top/Bottom Speed: 30 mm/s
Travel Speed: 40 mm/s
Initial Layer Speed: 30 mm/s
Initial Layer Travel Speed: 30 mm/s