Jump to content
Ultimaker Community of 3D Printing Experts

Leoboghozian

New member
  • Content Count

    1
  • Joined

  • Last visited

Everything posted by Leoboghozian

  1. Hello everyone, I hope that all is well. Recently I have been facing infill problems with my 3D prints on the Ultimaker 2+. I'm not sure why the printer is unable to finish the infill patterns. If you look at the pictures attached to this, you'll see that some of the grind lines are not complete. From the right to left, I have changed the speeds for each print to improve the quality but the infill problem keeps showing up, I'm unable to figure out why. Any help/suggestions will be appreciated. My last setting: Software: Ultimaker Cura 3.6
×
×
  • Create New...