Jump to content
Ultimaker Community of 3D Printing Experts

PROMETEJUS

Member
  • Content Count

    5
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
    SI
  • Industry
    Other

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. AN update on the problem, so like you sugested i printed the code that came with the printer but no luck. This means that the g code is not the problem. This leaves software, hardware or the motherboard. For the software i tried five differet versions of marlin and all had the same problem. For hardware i disconected the heated bed (i thought it might have been shorting the power supply), but that didn't help at all, i also checked all the conections and made shore nothing is overheating .The only thing teft is the motherboard, and i really hope it's not fried. The problem remains the same the
  2. So... I have yet another problem I've not been able to solve on my own. For the past two weeks, I've only had one successful print (out of 14), and the worst part is that I have no idea why. The problem is simple: The printer just randomly stops mid-print (usually in the first 40%). Things I have tried: I've attached a reliable power supplies, I've checked the steppers and the drivers (all OK), I've tried to use a different sd card and today I updated cura to cura 4.0 and tried to print via USB. Nothing worked, but the last time I tried (with the USB) Cura gave me a crash report⬇️. In case it
  3. I have had the ender 4 for about two months now, it works ok, but i've encounterd an issue for which I can't seem to find a solution. Whenever I try to print a circular object it gets streched along one of the printers diagonals and compressed along the other (it becomes eliptical). the difference is not too large obout half a milimeter on a circle with a radious of 2 cm. but its enought to cause me problems. Solutions i have tried: Ive tightened all the bolts and made shore everything was correctly assembled, Ive tried upgrading the firmvare an did quite a lot of calibration,(the xyz ca
  4. Thank you, I'll try to reduce power consumption. And do you think adding a powerful capacitor to the output of the power supply could help?
  5. I'm quite new to 3D printing and don't have much knowledge beyond the basics. I'm using Creality ender 4 based on ender 3. For the slicer, I use Ultimaker Cura 3.6.0 (I also use an SD card). So to describe my problem: Like the title says I've had plenty of seemingly random stops in my prints. It doesn't always happen (I've had about 3 failures for every success) The print starts normally and everything works as it should then suddenly without warning it stops mid layer, there is no error message and no option to continue the print. I've tried printing the same g-code many times and it never st
×
×
  • Create New...